Mon-Fri: 9am-6pm

FSP Non-modular 500W Power Supply (Bronze 80 Plus Certified)

FSP PS_FSP_500

Availability: In stock

Quick Overview

This unit will power most midrange systems with single graphics cards.  It will even run a dual card system for the lower end GPUs and represents an excellent value unit for a mid-range gaming system. FSP have built a name, not only for cracking prices and value, but mainly they are best recommended for their excellent reliability. Performance is one thing but the psu has to go on and on without fault.

More Views

Details

This is the specification of Model FSP500-60HCN; AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2. Also, +5Vsb power is less than 0.5Winput at power off mode (PS_ON input at high state) which is comply with ErP Lot 6 year 2013 requirement.

Specification

Model Name FSP500-60HCN
Wattage 500W
Dimension 140mm (L) × 150 mm (W) × 86mm (H)
Product Highlight Efficiency Level 78%
  Erp Lot <0.5W
  Input Voltage 230V
General Specification Effciency 78%
  PWOK Delay Time 500ms > PWOK > 100ms
  EMC performance EN55022 class B
EN55024
EN 61000-3-2
EN 61000-3-3
 
Input Electrical Specification Input Frequency 47 ~ 63 Hz
  Input Current 230V@ < 3.0 Amps - rms
Output Specification Output Rise Time +3.3V 20mS (maximum)
+5V 20mS (maximum)
+12 V1 20mS (maximum)
+12 V2 20mS (maximum)
-12 V 20mS (maximum)
Environmental Requirement Temperature Range Operating : 10 to +40℃
Storage :-20 to +80℃
  Humidity Operating : 85% to % RH, Non-condensing
Storage : 95% to % RH, Non-condensing
  MTBF The power supply reliability, when calculated by MIL-HDBK-217;latest revision, are exceed 100,000 hours with all output at typical load and an ambient temperature of 25℃.
Safety CE,TUV

Output Voltage and Current Rating

  +3.3V +5V +12V1 +12V2 -12V +5Vsb
Ripple-Noise(R-P) mV 50mV 50mV 120mV 120mV 120mV 50mV
Regulation Load % ±5% ±5% ±5% ±5% ±10% ±5%
Output Max.(A) 24A 24A 18A 18A 0.5A 2.5A
Output Min.(A) 0.1A 0.2A 0.1A 0.5A 0A 0A

Notes

 

( 1 ) +3.3V & +5V total output not exceed 123W
 
( 2 ) Maximum combined current for the +12V outputs shall be 36A.
 
( 3 ) +12V2 Peak current is 19A (less then 10m Sec.) , minimum voltage during peak is >11.0Vdc.
 
( 4 ) +5Vsb Peak current is 3.5A(less then 500m Sec.) , minimum voltage during peak is > 4.5Vdc.

Recommendations